Instructions / Assembly

Table Of Contents

1 ASSEMBLY

17. Join the rear sides of the Large and Small face

Plates (items #1 and #8) together using two

(2) M6 x 12 button head screws (H), two (2)

M6 Flat washers each (J), and M6 hex nuts (I).

Use a 4mm hex key and 10mm wrench to

tighten (Figure 17).

18. Attach the Large Face Plate (item 1) to the Left leg using the Large Face Plate Bracket assembly

(P). Follow the steps below: (See Figure 18)

a. Remove both of the M5 nuts and

screws from the angle bracket.

b. Insert the M5 x 40 (longer) screw

through the hole in the Left leg, and

slide the bracket onto it from the

inside surface. Thread the M5 nut

back on, and partially tighten.

c. Insert the M5 x 10 (shorter) screw

through the corresponding hole on

the edge of the Large Face Plate and

the hole in the angle bracket. Attach

the M5 nut, and then tighten both

screws and nuts with a 3mm hex key

and 8mm wrench.

Note: Continue with the steps on the

next page below if the FSC machine will

be wall-mounted. If you plan to use the

machine as a free-standing unit, please

proceed to step 24 now.

Figure 1

Left leg

Bracket assembly

Large Face plate

ure 17

Hardware bag h