Instructions / Assembly

2 Set Up & Calibration
17
9. Lower the Clamp Lever fully so that the stationary part and the moveable clamp are firmly
together.
10. Turn the eccentric left or right while attempting to remove the paper from between the
stationary part and the moveable clamp.
11. To verify clamping, attempt to remove the folded paper. When the paper cannot be
removed, the eccentric is providing proper clamping. Tighten the M6 Screw so that the
eccentric will not turn.
12. Raise the Clamp Lever fully and remove the paper.
13. The adjustment for the bottom eccentric is complete.
14. Repeat Steps 7 – 13 for the upper eccentric.
15. The clamp eccentric adjustments are completed. All three clamping areas now provide
proper material clamping.