Instructions / Assembly

3 Cutting Tools and Substrates
19
3.2 Installing New Cutting Blades/Wheels/Scoring Tips into Holders
CAUTION: Blades are extremely sharp. Handle with care.
A. ½" (13mm) or ¼" (7mm) Blade Holders
1. Loosen the Blade Clamp Screw on the Blade Holder using a
Phillips-head Screwdriver.
2. Slide the notched end of the Cutting Blade into the holder so it
nests on the Blade Stop Pin.
3. Tighten the screw securely.
♦ Note: Make sure the Blade is fully inserted into
the Blade Holder.
B. Cutting Wheel
Holders (Aluminum
Sheet and
Composites)
1. Position the Cutting
Wheels so the
beveled sides face
outward (see figure).
2. Place the Ball
Bearings into the
Cutting Wheel, and
then insert onto the Holder
studs.
3. Insert and tighten the Screws.
C. Acrylic Blade
1. Loosen the Blade Clamp Screw on the Blade Holder.
2. Slide the open notched end of the Cutting Blade into
the holder from the left side of the Screw Head.
♦ Note: Make sure the Blade is fully inserted
under the holding screw.
3. Tighten the screw securely.