Instructions / Assembly

3 Cutting Tools and Substrates
20
D. Glass Scoring Wheel
1. Position the new Glass Scoring Wheel in the gap so the
notch is positioned inward.
2. Gently rock it back-and-forth until it is firmly seated into
place.
3.3 Cutting Techniques for Various Substrates
Each material you will use has its own unique characteristics. Whether it is brittle, soft, thick, or
ridged in nature, you will need to choose the proper Cutting Blade/Wheel and technique to get the
best results. Refer to “Cutting Holder Types” Section 3.1 on page 18 for more information
on each Blade and Wheel Holder type.
♦ Note: To learn how to load the Blade/Wheel Holders, and all other general use
information, please refer to “Operating the FSC” beginning on page 23.
A. Cutting Foamboard/Gatorboard
1. Insert the ¼" (7mm) or the ½" (13mm) Blade Holder (refer to “Cutting Holder Types”
Section 3.1 on page 18 for proper blade selection) into the Cutting Head.
2. Lock the Holder Securing Knob.
3. Clamp the substrate in place.
4. Depress Thumb Lever and raise the Cutting Head above the material.
5. Release Thumb Lever and engage Rocker Arm Locking Pin to secure the Blade in the
forward position. . (See “Locking the Rocker Arm,” Section 4.6 on Page 25 for more
information.)
6. Pull the Cutting Head down in one continuous movement.
♦ Notes:
• A fresh Blade should cut the material in one pass.
• Production Stop should be used if making more than one piece of the same size.
B. Cutting PVC and Corrugated Plastic
1. Insert the ¼" (7mm) or ½" (13mm) Blade Holder (refer to “Cutting Holder Types”
Section 3.1 on page 18 for proper blade selection) into the Cutting Head.
2. Lock the Holder Securing Knob.
3. Clamp the substrate in place.
4. Depress Thumb Lever and raise the Cutting Head above the material.
5. Release the Thumb Lever and engage the Rocker Arm Locking Pin to secure the Blade
in the forward position. (See “Locking the Rocker Arm,” Section 4.6 on Page 25 for
more information.)
6. Pull the Cutting Head down in one smooth, continuous movement.
¾ Tip: For thinner material, such as polycarbonate, place a piece of sacrificial
material behind it to avoid slippage.