Instructions / Assembly

4 Operating the FSC
23
Operating the FSC
4.1 Inserting Cutting Tool Holders in the Cutting Head
1. Raise the Cutting Head to a comfortable level by grabbing either the Dual Handle Bar, or
the black Handle. Hold the Cutting Tool so the Blade Screw is to your right.
2. Insert the Blade Holder so the small tab on
the left side of the Blade Holder is
positioned in the notch of the Cutting Head
above the Dual Handle Bar.
3. Secure the Holder by tightening the Holder
Securing Knob.
4. Lower the Cutting Head to its resting
position at the base of the Vertical Track
Assembly.
♦ Note: The Holder Securing Knob must
be tight enough to hold each
Blade/Wheel Holder firmly in
place.
4.2 Clamping the Material
The Clamp will hold the substrate securely in place during the cutting process. This will allow the
proper dimensions to be maintained
.
A. To Close
1. Grasp the black Handle on the Vertical Track
Assembly.
2. Pivot the Handle downward to its closed
position.
B. To Open
1. Grasp the black Handle on the Vertical Track
Assembly.
2. Pivot the Handle back up to its opened position.
¾ Tip: If the material does not slide easily
between the Vertical Track Assembly
and the Clamp Assembly, check to make
sure the Clamp is fully open.
Pull lever downward to clamp