Instructions / Assembly

5 Laser Installation
26
M10 x 35mm mounting Bolt
Installing the Laser
5.1 Setting up the Laser
1. Loosen the black Handle by turning it counterclockwise.
2. Slide the Laser all the way to the left along the Laser Shaft.
3. Ensure the brass-tipped Set Screw on the Laser Assembly is tight against the Laser
Mount, and retighten the Handle.
4. Hold the Laser in the palm of your hand so the four (4) black Set Screws on the left side
of the Laser are facing you.
5. Loosen the four (4) Set Screws
using a 2mm Hex Key.
6. Tighten the center mounting
screw using a 1/8" Hex Key.
7. Retighten the four (4) Set
Screws just until they come in
contact with the Laser
.
5.2 Mounting the Laser to the FSC
♦ Note: You may need a stepladder to
complete this task.
1. If present, remove the existing M10
bolt from the mounting hole.
2. Align and attach the Laser Assembly
to the top, left-hand side of the
Vertical Track Assembly (see Figure
to the right).
3. Insert and tighten the M10 x 35mm
bolt supplied with the Laser using a
17mm Wrench.
Tools Needed
10mm, 16mm, 17mm Wrenches
2mm, 2.5mm, 4mm, & 1/8" Hex Keys
Center Mounting
Screw
Four Set Screws
Brass-Tipped
Set Screw
Laser Mount
♦ Note: Do not over tighten the Set Screws,
as you will be making some fine adjustments
to the Set Screws durin
g
calibration.