Instructions / Assembly

5 Laser Installation
27
RED Laser Line
enlarged for
illustration only
RED Laser Line
enlarged for
illustration only
5.3 Dual-Position Laser
A. Positioning the Laser for use with the Blade
(SILVER Tools) (PVC, Foamboard, Coroplast, Acrylic)
1. Loosen the black handle by turning it counterclockwise.
2. Slide the Laser all the way to the LEFT along the shaft.
3. Tighten the black handle by turning it clockwise.
B.
Positioning the Laser for use with the Wheel
(Color-coded RED) (Aluminum and Aluminum Composite Material)
1. Loosen the black handle by turning it counterclockwise.
2. Slide the Laser all the way to the RIGHT along the shaft.
3. Tighten the black handle by turning it clockwise.
5.4 Creating the Score Lines for Calibrating the Laser
1. Load a piece of sacrificial foamboard onto the Horizontal Material Bar. You can use another
material if foamboard is not available. Choose a softer material that will more clearly
show the score lines.
2. Place the ½" (13mm) Blade Holder in the FSC.
3. Create a score line the entire length of the foamboard – Do Not cut through completely.
4. Remove the ½" (13mm) Blade Holder and insert the Aluminum Composite Wheel Holder.
5. Place the Cutting Head at the top of the substrate and make a cut approximately 1" (25 mm) in
length.
6. Remove the Aluminum Composite Wheel Holder and return the Cutting Head to its resting
position at the bottom Vertical Track Assembly.
Wheeled Tools
Laser RIGHT
Blade Tool
Laser LEFT
♦Note: The FSC cutting tool holders are sized for cutting
performance. The “wheeled” tools are larger and
provide an off-set cut line compared to the blade tool.
The Laser Assembly is designed with a Dual Position
feature giving you the ease of positioning the Laser
Sight-Line to correspond to the cutting tool in use.