Instructions / Assembly

5 Laser Installation
29
♦ Note: Slight adjustments may be required for correct alignment.
If the beam falls across your substrate from top right to bottom left, use a 2mm Hex Key to:
1. Tighten the top Set Screw and the beam will move to the left. When it is positioned
over the top of the score line, stop tightening.
2. Tighten the bottom Set Screw and the beam will turn counterclockwise. When it is
positioned over the score line, stop tightening.
Securing the Laser in the Blade Cutting Position
1. Place a 2.5mm Hex Key in the brass-tipped Set Screw located on the top, left-hand side of
the Laser Assembly, and a 10mm Wrench on the Hex Nut opposite the Screw.
2. Tighten the Screw to create the Blade Cutting Laser Position.
Securing the Laser in the Cutting Wheel Position
1. Loosen the Handle and move the Laser to the far right on the Laser Shaft.
2. If the beam is to the right of the Aluminum Composite Wheel cut line:
a. Slowly tighten the Nylock Bolt, located to the far right end of the Laser Shaft,
using a 16mm Wrench.
b. When the beam is aligned with the wheel cut line, you are finished.
Beam is diagonal
right to left
Tightening top
Set Screw moves
beam left
Tightening front
Set Screw moves
beam counterclockwise
Beam is diagonal
to score line
Tightening back
Set Screw moves
beam clockwise
Tightening bottom
Set Screw moves
beam right