Full Product Manual

8.
Finishing the Fan
Installation
STANDARD CEILING MOUNTING
Align the locking slots of the ceiling canopy 1.
with the two screws in the mounting plate.
Push up to engage the slots and turn clock-
wise to lock in place. Immediately tighten
the two mounting screws rmly.
Install the remaining two mounting 2.
screws into the holes in the canopy and
tighten rmly.
Install the decorative canopy ring by 3.
aligning the ring’s slots with the screws
in the canopy. Rotate the ring counter-
clockwise to lock in place.
You may now proceed to attaching the 4.
fan blades.
Attaching the
Fan Blades
NOTE: Your fan blades are reversible. Select
the blade side nish which best accentuates
your decor.
Attach the blade to blade bracket using the 1.
screws as shown in gure 14. Please note
that the rubber washers are pre-attached
to the blade bracket. Start a screw into
the bracket. Repeat for the two remaining
screws.
Tighten each screw securely. 2.
CLOSE-TO-CEILING MOUNTING
Carefully unhook the fan from the mount-1.
ing plate and align the locking slots of the
ceiling canopy with the two screws in the
mounting plate. Push up to engage the slots
and turn clockwise to lock in place. Imme-
diately tighten the two mounting screws
rmly.
Install the remaining two mounting screws 2.
into the holes in the canopy and tighten
rmly.
Install the decorative canopy ring by align-3.
ing the ring’s slots with the screws in the
canopy. Rotate the ring clockwise to lock in
place.
You may now proceed to attaching the fan 4.
blades.
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE BOT-
TOM OF THE MOUNTING PLATE MUST REST IN
THE GROOVE OF THE HANGER BALL. FAILURE
TO PROPERLY SEAT THE TAB IN THE GROOVE
COULD CAUSE DAMAGE TO WIRING.
LOCKING SLOTS OF CEILING CANOPY ARE
PROVIDED ONLY AS AN AID TO MOUNTING.
DO NOT LEAVE FAN ASSEMBLY UNATTENDED
UNTIL ALL FOUR CANOPY SCREWS ARE EN-
GAGED AND FIRMLY TIGHTENED.
Figure 14
Fasten the blade assembly to the motor by 3.
inserting the alignment post into the slot on
the bottom of the motor and tightening the
blade bracket screws. Please note that the
blade bracket screws are pre-installed into
the blade bracket (Figure 15).