Instructions / Assembly

Assembly - Close-To-Ceiling Mount

Assembly - Hanging the Fan

Attaching the fan to the electrical

box

□ Pass the 120-Volt supply wires through the center hole in the

mounting bracket (A).

□ Install the ceiling mounting bracket on the outlet box by sliding

the mounting bracket (A) over the two screws (II) provided with

the outlet box. If necessary, use leveling washers (not included)

between the mounting bracket (A) and the outlet box. Note that

the at side of the mounting bracket (A) is toward the outlet box.

When using close-to-ceiling mounting, it is important that the

mounting bracket be level.

□ Securely tighten the two mounting screws (II).

WARNING: To reduce the risk of re, electric shock or personal

injury, mount to outlet box marked “Acceptable for fan support

of 35lbs. (15.9 Kg) or less”, and use screws provided with the

outlet box.

IIII

Close-to-Ceiling Mounting Routing the wires

1 2

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the four screws on the top of the canopy (C).

□ Remove the two non-slotted screws (WW) and loosen the

slotted screws.

□ Remove the canopy bottom cover (L) from the canopy (C) by

depressing the three studs.

□ Remove three of the six screws and lock washers (every other

one) securing the motor collar (M) to the top of the fan motor

housing (D).

□ Place the rubber gasket (EE) over the remaining three screws.

Make sure the slot opening is on top, then proceed to place

the ceiling canopy (C) over the collar at the top of the motor

(D).

□ Align the mounting holes with the holes in the motor (D) and

fasten, using the three screws and lock-washers removed

previously. Tighten the mounting screws securely.