Installation Guide

21
Fitting Assembly
Step 6 Attach ange nut to the installed HOME-FLEX®
tting
Place the HOME-FLEX® ange nut onto the
installed tting. Hand tighten the tting
assembly from the nut-end, then tighten to
the recommended torque value of 62 lbft
(generally, tighten with force until the nut
will no longer turn) using a second wrench
to hold the tting in place.
DO NOT use sealant on the parallel thread
of the socket.
Termination Fittings (Parts 11-464-XXX)
Termination Flange
Tubing
Retainer Ring
Fitting
Step 1 Cut HOME-FLEX® tubing to length
Route CSST through structure to the desired
location of the termination ange. Bend
tubing as required so it exits the structure in
desired direction of the termination plate.
Cut the excess CSST so about 2" of tubing
extends beyond the wall.
Step 2 Remove tubing jacket to prepare for tting
assembly
Using a utility knife, strip the yellow tubing
jacket back 2 valleys from the end of the
tubing. Also remove the yellow warning
label from the tting assembly.
DO NOT use a tube cutter.