Instructions / Assembly

Always check your building code. Thermo-treated wood is Class B ﬁre rated and most

panels are only allowed to be installed over a solid wall under most building codes.

INSTALLATION TYPES:

Adhesive

Double sided sticking foam tape (0.03” thick)

Finish nails (2D-3D size)

ADHESIVE APPLICATION:

Adhesive may be used to apply planks directly to walls as long as the surface is level,

sound and clean. Once the plank is ﬁtted, apply beads of adhesive with a caulking gun

in a continuous strip along the top, bottom and both sides of the plank.

Some supplemental nailing might be necessary to hold the strips in place until the

adhesive sets. Be sure to read the adhesive manufacturer’s instructions carefully prior

to installation, since instructions may vary.

TOOLS AND SUPPLIES FOR INSTALLATION:

Assemble all your tools and supplies before you begin the job. Here is what you will

need for most common wall paneling installations:

- Tape measure

- Level

- Pencil

- Power or table saw (12”+ cutting range) with short ﬁne-toothed blade

- Eye goggles (must be worn when using any power or hand tools)

Either one:

- Finish nail gun and nail set (2D-3D)

- Adhesive and caulking gun (if adhesive installation type is used)

- Double sided sticking foam tape (0.03” thick) 1” wide

PLANKS MEASUREMENTS:

Thickness: 7/16 in. or 5/16 in. (according to the speciﬁcation)

Width: 2-3/4 in., or 2-15/16 in., or 3-15/16 in., or 4-15/16 in. (according to the speciﬁcation)

Length: 23.5 in., or 23.75 in.

CARE AND MAINTENANCE:

It is recommended to use a vacuum to clean wood panels if needed.

Wood is a natural organic material, which might be fading under direct sunlight and any

bright light. To protect natural wood against color degradation, use standard wood oil or

lacker with UV protection. Spray it to the surface. Wood will appear darker when it oiled.