Instructions / Assembly

13 HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986 3460 for further assistance.

Installing the light kit plate

Assembly — Installing the Light Kit

□

Remove the 17-W LED assembly (J) from the light kit

plate (I) by removing three light kit plate screws (MM).

Set these screws (MM) aside for use later.

□

Place the key holes from the light kit plate (I) over the

two screws (LL) previously loosened from the fan motor

assembly (H) mounting ring. Turn the light kit plate (I)

until it locks in place at the narrow section of the key

holes. Secure by tightening the two screws (LL)

previously loosened and the one screw (LL) previously

removed.

□

Remove one of three screws (LL) from the fan motor

assembly (H) mounting ring and loosen, but do not

remove, the other two screws (LL).

CAUTION: To reduce the risk of electric shock,

disconnect the electrical supply circuit to the fan before

installing the light kit.

Installing the 17-W LED assembly

and glass shade

□

While holding the 17W LED assembly (J) under your

fan, rmly snap the wire connection plugs (OO)

together.

□

Position the 17W LED assembly (J) on the light kit

plate (I) and ensure the screw holes are properly

aligned.

□

Secure the 17W LED assembly (J) by replacing the

three screws (MM) previously removed. Tighten all

screws securely.

□

Attach the glass shade (K) to the light kit plate (I)

by twisting tightly.