Instructions / Assembly

Installation and Wiring Instructions
NOTE：ALWAYS TURN POWER OFF BEFORE INSTALLING LIGHTING FIXTURE
IMPORTANT：YOU SHOULD USE A QUALIFIED ELECTRICIAN TO INSTALL THIS FIXTURE
Installation (see Fig. A)
1.Disconnect power at main electrical panel before
installation.
2.Thread the mounting screws into the opposite side of
the mounting plate from the GREEN ground screw.
3.Guide fixture wires through hole in center of the
mounting plate.
4.Follow wiring instructions carefully (listed below).
5.Attach mounting plate to outlet box using box screws
provided with outlet box.
6.Thread Hexnut onto mounting screws.
7.Mount fixture by aligning mounting holes in canopy
with mounting screws and threading ball nuts onto
mounting screws. Tighten to firmly hold canopy in
place against wall(mounting screws may require
adjustment).
Wiring (see Fig. B)
1.Split the conductors of the fixture wire about 4
inches. Being careful not to expose any of the wire
inside of the insulation.
Fig. A
Fig. B
2.Connect the fixture ground wire to the outlet box ground wire using wirenut(not provided). Connect outlet
box ground wire to mounting plate with GREENhex-head ground screw to appendex hole in mounting plate
marked “GND”.
3.Connect the half of the fixture wire that is white marked or has a triple surface to the outlet box supply
wire(WHITE). Connect the other half of the fixture wire that is black marked or has a smooth surface to the
outlet box supply wire (Black or Red). Use wirenuts provided.
4.Spread the electrical supplies so that the black wire are on one side of the outlet box and white wire are on
the other side.