Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com 1 INS3500
Read all instructions completely before installing. Should you have any questions about your installation, please call
Customer Service at 440-248-5480. Missing and damaged parts must be reported within 5 days from receipt of
delivery.
Tools needed for this installation (Not Supplied with Kit)
Level - Pencil or marker - Phillips head screw driver – ½” Standard drill bit for hollow wall installation – Safety glasses
– 5/16” Masonry bit for concrete block installation – 1/16” Standard drill bit for stud wall installation – Tape measure
Parts Listing
P/N# Qty Description Qty
Hardware______________________
10-01815T 1 Top Track Sections 5 2-1/2” Bolts
10-0280-1T 2 Top Hang Rail with hanging Slots 6 3-1/2” Bolts
10-0280-2T 2 Bottom Hang Rail Section 11 White Plastic Wall Anchors
10-0280-3T 2 Hang Rail Connector with 2 bolts 11 2-1/4” Wood Screws
10-2004T 5 Shoe Racks 11 Toggle Bolt Expanders
1 Hex Head Wrench for Hang Rails
We have included all mounting hardware for hollow and concrete block wall installations. It is not necessary to mount
system to wood studs. Each system will require 35 lineal Inches of wall space for mounting and a minimum ceiling height
of 7-1/2 feet high for proper clearance.
Drill Diameter Listing: Drill diameter sizing for hollow wall installations: Use 1/2” standard drill bit
Drill diameter sizing for concrete wall installations: Use 5/16” masonry drill bit
Drill diameter sizing for wood Stud wall installations: Use 1/16” standard drill bit for pilot holes
Preparation for Top Track Installation: (Image A-1)
1. When installing in a corner, leave 1” space between side wall and your top track.
2. Determine the maximum height of storage you would like available above your system. (See Fig. A-1). For an 8
foot ceiling; 78” off the floor leaves 18” of storage above and 81” leaves 15” storage above.
3. Using a tape measure, mark your desired height off the floor with a 4” long pencil mark.
4. (Refer to Fig. A-1 & A-2) Using a level, align top of top track with your pencil mark in step 3. With top track level,
mark the center of each hole’s location on your wall. (Note: Before starting to drill holes always make sure all
screw hole locations do not fall in line with electrical wires, duct work or plumbing inside of your wall. If a
potential problem exists, reposition and remark screw hole locations.)
5. (Fig. A-2) Drill hole locations marked using the correct drill diameter sizing and type listed above. Should you
come in contact with wood studs, stop and mark the hole with X and after drilling all other holes come back and
drill these holes using a 1/16” bit for pilot hole for wood screws.
Attachment of Top Track to Wall Surfaces: (Fig. A-3)
6. For hollow walls; (Fig. A-3) Use 2-1/2” long toggle bolts with expanders. Insert all toggle bolts through top track
and attach all toggle bolt expanders. Omit toggle bolts that fall in line with X or wood studs. Insert toggle bolts
with expanders into holes in wall before starting step 9.
7. For concrete walls; use white plastic wall anchors and 2-1/4” long wood screws. Install all plastic wall anchors in
all hole locations before starting step 9.
1565 - (5) Tier Shoe and Boot Rack 14"D x 63"H x 33"W