Instructions / Assembly

FLAT STOCK
INSTALLATION GUIDELINES
These basic installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed
professional, and to check with your local building inspector or building permit office for approvals and possible variations that may apply.
Flat Stock can be used for custom flashing and do-it-yourself projects.
Carefully measure and mark where
flashing is to be cut and bent. Lightly
scribe the fold lines with a utility knife
or marking gauge.
Roll flashing can heavily scribed, using
a straight edge and utility knife, then
bent until it snaps; or it can be easily
cut with “tin snips”.
Make crisp bends with a professional
brake, or clamp the flashing material
between two straight wooden blocks.
Refine the edges with a rubber mallet.
MEASURE CUT BEND
Drip Cap
J-Channel
Z-Flashing
J Channel
Termite
Shield
Angle
Flashing
Dormer
Flashing
Custom Roof Edges
Custom Fascia
Brick
Moulding
135°
Repair
& Rodent
Control
Patch
Bottom
Board
Top
Board
Fold
Fold
Chimney Flashing, Low Side
Chimney Flashing, High Side
6"
Cut
Cut
Width of
Chimney
6"
6"
6"
8"
24"
Caution: The edges are extremely sharp!
Work Gloves are ESSENTIAL.