User manual

WinPC-NC Light First steps
WinPC-NC is using the following signals for motor actuation...
Pin 2 direction motor X
Pin 3 clock motor X
Pin 4 direction motor Y
Pin 5 clock motor Y
Pin 6 direction motor Z
Pin 7 clock motor Z
Pin 8 direction motor 4
Pin 9 clock motor 4
i
Using a SMC steppermotor card it is not necessary to consider
the exact signal assignment. It is sufficient to utilize a commonly
used printer cable for connecting LPT port and SMC card.
In order to detect the LPT port address you have to call up the device
manager in the system control.
Please perform the following steps...
• open the device manager under My computer, control panel
system, hardware
• open the category ports COM & LPT and select the LPT port
which is connected to the machine
• select by the right mouse button the function properties and then
resources
• note the port address under which the LPT port is registered in the
system. With onboard ports it is usually the port address 0378hex.
Locating the LPT port by means of the device manager
- 16 -