User manual

WinPC-NC Light Operating WinPC-NC
SPECIAL FUNCTIONS-SIGNAL TEST
This test function can be used for checking the axis inputs of the
controller, i.e. the limit and reference switches, as well as the outputs.
Signal test
Interactive
testing of all
inputs/outputs
WinPC-NC continuously interrogates the limit switches and
reference switches on all supported axes and displays their status.
Grayed out switches are not defined.
Black indicates the switch is not active, while red displays that the
switch is activated.
i
Definiton of the switches and setup of the switching logic must
be executed during installation by the signal wizzard under
parameter-machine-signals.
The supported additional signals are tested by simply clicking the
LED symbols. This switches the outputs on or off.
- 31 -
Signal test
Motor test
Status information
Joystick calibration
Check position