User manual

WinPC-NC Light Parameter settings
Save last positions
WinPC-NC can save the current machine position after each
movement and job. This is meaningful if the machine works without
reference switches or if it is not always possible to carry out a
reference movement.
The position values remain unchanged even after exiting or restarting
the program.
Button orientation
Adapting the
movement
direction of the
buttons
It is possible to use 4 settings to rotate the X and Y-axis directions
through 90 degrees at a time in order to adapt the orientation of the
movement buttons in jog mode to take account of the machine
orientation.
Button orientation position 0
Button orientation position 1
Positions 2 and 3 turn the X and Y buttons through further 90 degree
steps.
Program repetitions
The program repetitions parameter enables you to repeat a working
process up to 999 times. This enables series production to be
achieved in conjunction with a start signal.
- 51 -