User manual

WinPC-NC Light Initial start-up with the machine
1. Open the device manager under My computer, control panel,
system, hardware
2. Open the category Ports COM & LPT and select the LPT port to
which the machine is connected.
3. Click with the right mouse button to properties followed by
resources
4. Note the port address under which the LPT port is integrated into
the system. With onboard ports it is normally port address
0378hex
Identification of the LPT port address by the device manager
The detected port adress has to be registered in WinPC-NC under
paramater machine-signals-port addresses followed by clicking
Save and OK.
After this process a simple test run with the function JOG MOVE or
MOTOR TEST should be possible. Please act with the greatest
possible care and be always aware of uncontrolled machine
movements. If the axes do not move smooth or move at all, just
increase the clock length parameter step by step.
i
When delivered the LPT port address is registered under
0378hex. This registration applies to most internal ports.
- 64 -