User manual

WinPC-NC Light Signal wizzard
i
With inputs WinPC-NC reacts only to a HIGH level. Please take
care that the switching logic with the possibility for inverting is
assigned in the way that an activated switch generates a HIGH
level.
6.3. Assignment of output lines
Assignment
of outputs
The assignment of outputs is similar to the assignment of inputs.
Please carry out the following steps :
1. Connect the required cables to the available pins and use for
control purposes a LED light or a lamp.
2. Click to Signal test and observe the LEDs in the next window
which are symbolizing the status of the individual output lines
Interactive signal testing
3. Click by mouse on to the possible outputs and observe the level of
the cables. A blue LED light signalizes a LOW level or an output
switched off. A green LED light signalizes a HIGH level or an
output switched on. Please note or notice the corresponding pins
as well as the switching logic.
4. Click to the button Done and change again into the window of the
signal wizzard. Select now the corresponding output signal in the
right-hand window (e.g. Q242 spindle on/off) and open the drop-
down menu below in order to assign the pin number (e.g. LPT1
PIN1).
5. After clicking the button Accept the selected pin number is
displayed in the assignment table.
- 73 -