User manual

WinPC-NC Light Additional Information
And here is the same example in format 1: (always 5-digit values,
with trailing zeros discarded)
Sample of drilling
data in format 1
Short drilling program in
format 1
%
T1
X01Y01
X012Y0234
X027Y0295T2
Y01
M30
Remark lines
Start of program
Select tool 1
Drill hole at 1000/1000
Drill hole at 1200/2340
Tool 2 drill hole at 2700/2950
Drill hole at 2700/1000
End of program
7.2. Error messages
Error messages are displayed in a small window in the middle of the
screen during operations in WinPC-NC.Messages in a gray box do
not indicate there is a fault, but only provide information.
The following error messages may occur :
• Limit switch reached
The machine has moved on to one of the limit switches. It is necessary to move
back from the switch and perform reference rung again before continuing work.
• Machine not ready
The connected controller or machine is not ready or not switched on. WinPC-NC
works in demo modes.
•HPGL syntax error
There is an invalid HPGL command in the plotter file. It does not correspond to the
syntactical rules and therefore cannot be processed by WinPC-NC.
• Connection canceled
The connection to the DLL-controller is interrupted. This can happen when other
window programs or drives interfere with the realtime tasks.
• Status stack full/empty
An internal error has occurred in WinPC-NC. Please report this error to the
program authors, providing as many details as possible.
• Incorrect parameter
A parameter in the WPI or WPW file is incorrect or the parameter file has been
corrupted.
• Stop signal detected
The stop signal has been detected. Please rectify the fault
.
• Go to reference position first
WinPC-NC and the controller always need to know what their current position is.
Please always perform reference travel after restarting the program.
- 79 -