User manual

WinPC-NC Light Additional Information
• Error xx from controller
An internal error has occurred in WinPC-NC during communcation with the
realtime module. Please report this error to the program authors, providing as many
details as possible.
• Data cannot be displayed
The NC data for the current file cannot be displayed graphically. Either they do not
match the selected format or they do not contain any tool actions. Another cause for
failure may be that the format identification is switched off or that an incorrect data
format has been adjusted.
• Tool not yet defined
A tool is needed which has not yet been programmed in the tool management
system. The appropriate parameters must always be defined prior to using tools.
• No tool file found
No tool file can be found. WinPC-NC therefore continues to work with default
values.
• Machine is at limit switch
When both limit switches on an axis are defined, WinPC-NC is unable to tell which
switch has been reached. Please move the axes in question back from the limit
switch manually and then restart reference travel.
• Service code required
The axis controller can no longer be controlled and requires a service code before
continuing work. Please contact the supplier.
• Command rejected by controller
An internal error has occurred in WinPC-NC during communication with the
realtime module. Please report this error to the program authors, providing as many
details as possible.
• Maschine not ready
The machine has not been switched on or there is a fault. The NOT READY input
on the axis controller signals this condition.
• Communication failed / Timeout
Communcation of WinPC-NC interferes with the realtime-DLL. Please report this
error to the program authors, providing as many details as possible.
• Protection hood not closed
The protective hood or another protective device has not been closed and therefore
no process can be started. The machine can still be set up.
• Command rejected during machine movement
There is a fault in the connection between WinPC-NC and the realtime module.
Please report this error to the program authors, providing as many details as
possible.
• File with invalid format
The selected file does not match the set data format. Change the parameter or the
data format to HPGL or drilling format.
• Help file not found
The file with the help texts cannot be found. It is called WINPCNC.HLP and must
be located in the current folder or in the WinPC-NC folder. No help texts can be
displayed.
- 80 -