User manual

WinPC-NC Economy Operating WinPC-NC
WinPC-NC controls the X and Y motors during move commands.
The Z motor moves up and down during tool movement commands.
All three axes can move at the same time in 3D files.
Progress display During machining, a window displays the progress as a percentage.
In additon the realtime file display is available where the current
performed command line is marked by a cursor bar.
Display of progress and speed override
Speed override Clicking the greater than/less than button in the window makes it
possible to change the feed rate of the machine as well as the spindle
speed in 5% steps. The valid range is from 10% to 200%.
A working process can be cancelled by clicking the CANCEL button
in the progress display window, or by pressing the (ESC) key. The
machine brakes all axes without losing any steps and switches off the
spindle and the cooling function.
Resuming an
interrupted job
When you start again after a cancel, WinPC-NC asks whether the
interrupted process should be resumed from the point where it was
cancelled, or whether the process should be started over again.
During an interruption, it is possible to change parameters, clean the
tool or even perform jog movement and homing the machine.
The continuation of an interrupted job has to be enabled in the
parameters.
Continuation of an interrupted job
- 25 -