User manual

WinPC-NC Economy Operating WinPC-NC
WinPC-NC can move the axes endlessly, i.e. movement continues
for as long as a key remains pressed. The axis brakes when the key is
released and comes to a stop without any step losses. The second
possibility involves moving discrete distances. Distances between
0.01mm and 100mm are possible, as well as inch dimensions. The
currently set distance is displayed in the window. WinPC-NC moves
this distance in any required direction and with both possible speeds,
depending on which button or key is pressed.
In addition to the predefined distances, it is possible to enter any
distance in the text box.
Switching
additional signals
Clicking the check boxes with the mouse is all that is required to
switch the additional signals drilling spindle and coolant pump. This
switches the signals on or off. Both signals are switched off when
you exit the JOG function.
During manual movement, it is possible to move
and store certain help points. After a position has been
reached, it is easy to click the Save button to select the
required point and save it permanently as a
parameter.
Moving to saved help points is just as staightforward.
All that is required is to click the Move to button and
select the required help point. Then the machine
moves to it.
Movement in progress can be interrupted at any
time by clicking the Stop button.
The JOG function can be exited by clicking the the
Exit button.
Automatic
measurement of
Z-heights
WinPC-NC can automatically determine the various Z-axis heights
using a probe or surface block sensor. The sensor should be
connected to an input on the LPT port using a cable to allow the
block sensor to move freely. Depending on which Z-axis height you
are measuring, place the probe against the clamped workpiece or the
table surface to measure the maximum Z-axis depth
The measuring sequence involves serveral steps :
1. Move the machine over the point to be measured
2. Place the probe or surface block onto the piece but under the tool.
3. Start the measurement. WinPC-NC moves the Z axis downwards
slowly until the probe contact trips. Then the axis stops and
WinPC-NC transfers the measured value and the probe width as
parameters. The probe width can be defined as a parameter.
- 27 -