User manual
WinPC-NC Economy Parameter settings
Automatic length correction
This parameter activates automatic tool length compensation. Having
a separate parameter to enable this function makes it possible to
restrict compensation to projects in which it is really needed.
i
Tools are not automatically measured after being changed.
Instead, this measurement must be explicitly selected using the
MEASURE TOOL function before each tool is used.
Length check after tool changed
This parameter enables WinPC-NC to perform a tool length check
after each tool change.
Fast move to sensor with brake
To speed up the process you can activate the two step measurement
and force WinPC-NC to move to the sensor with fast manual speed,
brake the movement, reject the tool over the sensor and do the
measurement in a second step precisely.
4.2. Speeds
All the parameters which control the speeds of the motors are
grouped together in the Speeds dialog box.
The optimum parameter values for the required speeds can be
determined using the MOTOR TEST function.
All parameters must be set separately for X, Y and Z. This means the
correct speed can always be calculated and used, even when different
axis resolutions are involved.
- 46 -