User manual

WinPC-NC Economy Parameter settings
Output signals with M commands
In G code programs, it is possible to switch almost all outputs such as
the spindle, cooling, etc.using M commands. This parameter prevents
WinPC-NC from operating a signal automatically and forces it to
utilize exclusively the M commands which are used.
Otherwise, WinPC-NC would automatically switch on the spindle at
the start of the process and switch the cooling on and off when lifting
and lowering the tool.
Mirror axes
The X and Y-axes and their coordinates can be mirrored
independently of one another for all formats. A changed parameter is
immediately visible in the graphical display.
Rotation of X/Y axes
The NC data can be rotated around the zero point, e. g. for a better
placement on the material. Rotation always happens in 90 degree
steps.
File realtime display
It is possible to obtain a general view of the current program position
during a job by a file display. This display shows in realtime the
actual executed command by a cursor bar during operation.
The file display realtime applies to all formats, excepting postscript
format and shows files of up to 32000 lines.
- 60 -