User manual

WinPC-NC Economy Parameter settings

Please note that certain macro commands like offset or macros

for certain additional functions, e. g. automatic tool changer, are

only usable by WinPC-NC Professional.

Do not operate signals automatically

Outputs

automatic or

with macros

Normally, WinPC-NC operates a few output signals automatically.

For example, the Job in progress output is set at the start of a

working process and reset at the end or after a cancel. Equally, the

following signals are also set automatically: Drilling spindle,

Coolant pump, Dispensing, etc.

If it is better for the signals to be operated with the macros or if you

want to change the times when they are operated, then you must

switch off automatic operation with this parameter.

Following this, all signals can only be operated using macros.

Switching off macros

Using macros can be generally switched on or off by this parameter.

- 81 -