User manual

WinPC-NC Economy Initial start-up with the machine
5. Initial start-up with the machine
Machine
adjustment
After software installation on your PC it is necessary to carry out
some start-up processes and corresponding adjustments.
This procedure is only necessary with the initial start-up procedure
and generally relates to the adjustment of your machine. In case if
you have acquired WinPC-NC Economy together with the machine
either most of the paramaters are correctly preadjusted or you have
received an additional disk with the corresponding adjustments. If
this is the case the following described procedure can be disregarded.
5.1. Connecting the machine
Connecting the machine is made on one or two LPT printer ports of
the PC and the corresponding cables or adapters have to be used or
manufactured.
i
Attention !
Greatest care has to be taken when connecting all cables to the
housing. Following actions can cause serious damage:
Incorrect assignment of the signal cable, plug incorrectly
inserted, cables incorrectly connected.
Starting the entire unit is not allowed until all necessary and state
specific safety rules have been accomplished and checked. The user
is responsible for unit operation.
i
Attention !
For further interrogation of the status emergency stop or ready
for operation it is essential to use one of the inputs. In this way it
is possible for the control to stop actuation of output signals if
necessary. Detailed information is provided in the
documentation concerning controlling software. Please observe
all instructions concerning machine safety.
- 82 -