User manual

WinPC-NC Economy Initial start-up with the machine
The detected port adress has to be registered in WinPC-NC under
paramater machine-signals-port addresses followed by clicking
Save and OK.
After this process a simple test run with the function JOG MOVE or
MOTOR TEST should be possible. Please act with the greatest
possible care and be always aware of uncontrolled machine
movements. If the axes do not move smooth or move at all, just
increase the clock length parameter step by step.
i
When delivered the LPT port address is registered under
0378hex. This registration applies to most internal ports.
5.4. Determination of direction
Call the function JOG MOVE and move all axes with the cursor
button or by mouse clicking to the arrow buttons and check machine
direction.
Each button corresponds to a certain axis or direction . Please start
with axis X.
Arrow keys showing to the right side are to start a positive movement
of the X-axis, i.e. following movement to the right of the machine.
Arrow keys showing to the left side are to move the machine left in
opposite direction.
If this is not the case, one of the following errors may have occured...
Error Possible cause Solution
Machine does
not move
Incorrect port
Incorrect port pinning
Maschine off
Port adjustment
Control of pinnings
Check whether motors
are energized and
provide supply
- 87 -