User manual

WinPC-NC Economy Initial start-up with the machine
Error Possible cause Solution
Movement of the
wrong axis
Incorrect port pinning Control and adjust the
port pinnings
Axis X moves
always in
opposite
direction, i.e.
moves to the left
by activated
right-hand arrow
and the other
way round
Direction signal works
with incorrect logic
Change the parameter
INVERT MOVE
DIRECTION under
machine parameters
After checking the X-axis a further test of the both other axes is
advisable. If necessary, please correct move direction by parameter.
The machine has to move backwards when arrow keys showing to
the top.
The Z-axis moves down when
arrow keys showing downwards.
For a direction reversal of one axis
it is only necessary to change the
parameter INVERT MOVE
DIRECTION.
i
The move directions to be determined are always relating to the
movement of the tool above the workpiece. Please pay attention
to the correct setting of move directions by mechanics with
moved table. The moved table runs always opposite to the arrow
keys in order to guarantee a correct move direction of the tool
above the workpiece.
- 88 -