User manual

WinPC-NC Economy Initial start-up with the machine
A detailed description of the signal wizzard and the possibilities for
defining and setting the inputs and outputs is listed in the next
chapter.
5.6. Sequence and direction of reference move
In the following step settings for reference move of the machine are
stipulated. Please carry out the following steps:
1. Open parameter dialog box parameter-machine
2. Under reference switch at pos./neg. end you have to adjust on
which axis side the switch is located. If it is not possible to be
directly ascertained, change again to the function JOG MOVE and
check by moving and oberserving the position counters and note
to which position the axes move to in the moment when they are
approaching the switch.
3. After the setting of all switches there is nothing else to do than
selecting the reference sequence. The desired sequence can be
stipulated in the drop-down menu. Normally it is always the Z-
axis which starts moving upon to it's switch followed by the other
axes.
4. If you intend a reference move of one or several axes into positive
direction, it makes sense to place the machine zero point not at the
switch but define another position by parameter.
5.7. Control of settings
After respecting all items a reference move with your machine should
not cause any problems. Subsequent to the execution and saving of
all parameter settings please press the function key
(F8) or select the
corresponding function by menu.
Reference move
for control
During the reference move all axes run upwards to their switch
according to the adjusted sequence and then downwards the switch
with reduced speed. Exactly at the switching edge all axes are
stopping and marking the reference point.
If this procedure should cause problems or stop with indicating error
messages some of the settings have been incorrectly carried out. The
tabulation below provides additional information concerning
different kinds of errors and corresponding solutions.
- 90 -