User manual

WinPC-NC Economy Signal wizzard
6.5. Output signals available
Possible outputs
WinPC-NC is able to manage the following output signals :
Output signal Assigned actions
Q255 Ready Indicates whether the controlling software is ready with
HIGH level. In the case of error the output turns to LOW.
Q251 Axis moves Indicates moving (HIGH) or stopping (LOW) axes. This
signal can be used for reducing current at the rating
class limits.
Q250 Boost Indicates ramp moving during the run of axes (HIGH) or
displays stopped axes respectively constantly moving
axes (LOW). This signal can be used for reducing
current at the rating class limits.
Q242 Spindle Switches on/off the drilling-/milling spindle.
Q243 Cooling Switches on/off the coolant pump or the spray cooling
Q244 Dispensing Switches on/off the dispensing signal.
Q245 Purging with
compressed air
Indicates with HIGH level an upwards moving and thus a
withdrawing Z-axis.
Q246 Job works Job working in HIGH level and thus indicates automatic
operation.
Q249 Spindle
lefthand/righthand
Switches the rotation direction of the milling spindle, e.g
by M-functions M3 and M4 in G code programs.
Q100-107 Output Mxx Additional outputs, programmable with M-functions in G
code programs.
Q220-230 vacant Signals freely to dispose, with macro programming.
All additional output signals which are indicated in the table are
reserved to special functions or only available in WinPC-NC
Professional.
- 97 -