User manual

57
6. General Notes on Rechargeable Batteries
• Keep the rechargeable battery out of reach of children.
• Leaking or damaged batteries/rechargeable batteries can cause chemical burns to skin
when touched without the use of adequate protective gloves.
• The rechargeable battery must never be short-circuited or thrown into fire. There is a risk of
fire and explosion!
• Never open or disassemble the rechargeable battery!
• If the rechargeable battery heats up strongly when charging, interrupt the charging process!
• Never charge the battery unsupervised.
• For reasons of safety, only charge the rechargeable battery on a heat-resistant surface.
• If the rechargeable battery shows any deformation, holes or other obvious defects, no longer
use the rechargeable battery and do not try to charge it.
• Dispose of the rechargeable battery environmentally compatibly.
7. Operating Conditions
Operate the module only with an operating voltage between 5 and 32 V/DC and observe
polarity. The power source must be able to deliver at least 700 mA.
The maximum switching output of the relay (OUT1) is 5 A at 30 V/DC or 8 A at
250 V/AC.
The maximum switching output of the transistor output (OUT2) is 300 mA at 32 V/DC.
When installing the module, ensure a sufficient cable cross-section of the connection lines.
The module can be installed in any position.
To warrant the “GX107” function, select an assembly site where the GSM network can be
received. This means that the site must not be shielded by reinforced concrete walls,
metallised mirrors, plate shelves, etc.
There is the option of using an external aerial (available as an accessory).
No devices with strong electric fields, such as mobile phones, radio devices, electric engines,
etc., should be in the proximity of the camera.