User manual

13. System Commands

With the following commands, you can change important protective functions of the “GX107”.

If you have the default settings, you thereby accept the resulting changed behaviour of the

“GX107”.

13.1 Alarm Timer

In case of alarm, the “GX107” will send an alarm message. Further messages of the same type

are only sent if the corresponding alarm situation was left for a specified period (factory

settings: 5 minutes). This period can be changed.

Use the following text message command:

SET IDLEALARM <Time> #1513

The time can be set between 1 and 240 minutes.

Example:

SET IDLEALARM 15 #1513

The period between alarm messages is now 15 minutes.

Attention!

During this period, you will not be informed that the reason for alarm has changed

again. Observe that you must check the parameter yourself during this period.

Reset to factory settings

Send the following command to reset to factory settings (5 minutes):

RESET IDLEALARM #1513

Checking settings

To verify the desired settings, use the command:

TEST IDLEALARM #1513