GUIN_Instru_2012 1/12/15 5:20 PM Page 1 Instructions Use & Tips
GUIN_Instru_2012 1/12/15 5:20 PM Page 2 Sanding & Polishing With The Guinevere® Flexible Finisher Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Air Pressure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Inflating and Deflating Sanders . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Pliancy Test . . . . . . . . . . . . . . . . . . . . . .
GUIN_Instru_2012 1/12/15 5:20 PM Page 3 Introduction Congratulations! You have just purchased one of the finest sanding and polishing kits in the world. The Guinevere® Flexible Finisher is a total system for final sanding, waxing and polishing. Guinevere sanding sleeves are made of highly flexible, top quality abrasive cloths, ensuring an extremely long life for each sanding sleeve. They are excellent for wood and may also be used to finish metal, bone, horn and other materials.
GUIN_Instru_2012 1/12/15 5:20 PM Page 4 1. Grip the sander with your thumb, index finger, and middle finger. 2. Insert the pump on the drive shaft and then grip the pump using your ring finger and little finger. 3. Pump 1–2 times with small distinct thrusts. TIP: Hold the Guinevere sander and pump in one hand and pump with the other hand. Long Drum Sanders (8mm air shaft diameter vs 6mm for round, drum & short sanders) 1. TO INFLATE: Tighten the brass ring on the micro pump until it is finger tight. 2.
GUIN_Instru_2012 1/12/15 5:20 PM Page 5 Pliancy Test A simple pliancy test may be performed by pressing the sander together using your thumb and index finger. It should be easy to press down the rubber and sanding sleeve against the inner spindle. An alternative test is to take a 3/8” (10mm) dowel or pencil in diameter and press it in the middle of the sander. It should be easy to press the sander together against the inner spindle.
GUIN_Instru_2012 1/12/15 5:20 PM Page 6 Fitting Brush Sleeves and Cloth Sleeves The instructions for mounting, inflation and deflation of brush and cloth sleeves are the same as for the sanding sleeves.
GUIN_Instru_2012 1/12/15 5:20 PM Page 7 2. Undulations (waves) - There are always some fibers that are livelier than others even when the final sanding has been done. This may be because certain fibers absorbed water more easily than others or due to sanding with a heavily clogged abrasive sleeve resulting in fibers being pressed down on the surface. Also, the belief that by pressing hard improves the sanding result is incorrect.
GUIN_Instru_2012 1/12/15 5:20 PM Page 8 TIP 1: The inflatable sanders are surprisingly aggressive in comparison with other types of sanding sleeves or when sanding by hand. As soon as you feel the sander is removing too much, switch to a finer grit. TIP 2: Over very uneven materials where you want an even surface, you should move the sander quickly back and forth so that the tops are successfully sanded down.
GUIN_Instru_2012 1/12/15 5:20 PM Page 9 Drying Time Guinevere’s Organic Oil Wax dries in 1–4 days, curing time 2 weeks. It is non-toxic in every stage of drying and can be used safely on objects that come into contact with food. It leaves the wood as natural looking as possible, with an incredibly smooth finish. Coverage Apply wax in small sections 300ml covers approximately 19-26 sq. ft. (6-8 m2). 50ml covers approximately 3-4 sq. ft (1-1.
GUIN_Instru_2012 1/12/15 5:20 PM Page 10 To increase gloss, or for a more lustrous surface shine as well as further improve surface protection, you can apply Guinevere wax in one or more additional layers. Each layer should be applied thinly and left to dry for a couple of days before the next layer is applied. After each application, wax the surface with a brush sleeve when the oil has dried and hardened a little.
GUIN_Instru_2012 1/12/15 5:20 PM Page 11 SAFETY There is a risk of cloths and paper saturated in linseed oil spontaneously combusting. You should flush any paper you have used down the toilet or burn it – safely! After use, Guinevere brush and cloth sleeves should be kept fully sealed in glass jars. Surface Treatment Surface treatment is a science in itself! Rough and poorly sanded wood surfaces require a great deal of treatment; however, any wooden surface can be treated in many different ways.
GUIN_Instru_2012 1/12/15 5:20 PM Page 12 GUINEVERE® Parts & Accessories Part # 11300 11395 11320 11321 11322 11331 Sanding & Polishing Motor Sanding & Polishing Motor 220 Volt Hand Pump Swedish Organic Wax 50 ML Swedish Organic Wax 300 ML Cleaning Stick 11341 Inflatable Round Sander 11343 11344 11345 11346 11347 11348 11349 11342 4 Assorted Round Sleeves 3 Coarse Round Sleeves 60g 3 Medium Round Sleeves 120g 3 Fine Round Sleeves 180g 3 Extra Fine Round Sleeves 320g Replacement Round Sander Bulb 2 Clo