User manual

11
Step 3 (see page 24)
Attach the carrier handle (13) with the short screws (16) on the housing of the ventilator. Now slide the hose clamp (12) over the
extraction pipe (10) and then on the opening of the air intake of the ventilator (6) and screw the hose clamp tight. Then screw the feet
(14) on the housing of the ventilator. (ON/OFF switch)
Step 4 (see page 25)
Attach the four-part edge protector (11) to the edges of the housing.
Step 5 (see page 25)
Place the hood (4), the connection piece (9) and the ventilator cover (8) in the inside of the housing and attach the whole assembly
to the ventilator (6) with the long screws (15).
Please note that there are three possible installation directions for the ventilator (6) depending on use. (See the illustration
"Installation of the ventilator".)
Step 6 (see page 25)
Now place the filter 2 (17) and filter 1 (5) in front of the extraction opening of the ventilator (6).
Step 7 (see page 25)
Afterwards, place the rotary table (7) in the center of the casing.
Installation of the ventilator
(See page 25)
The ventilator (6) can be installed in three different directions, depending on the respective task.
Operation

Observe the chapter "Safety instructions".
1. Place the airbrush extraction system on a stable and even
surface.
2. Guide the extraction pipe (10) out of the window or a wall
opening to the outside.
2. Insert the mains plug into a mains socket.
3. You can turn the device on and off with the ON/OFF
switch, see ill., step 3.