User manual

8

Introduction
Dear customer,
In purchasing this product, you have made a very good decision. We are quite sure that you will have much enjoyment with
this product.
You have purchased a quality product from Conrad which has undergone our stringent tests and corresponds to our quality stan-
dards.
These operating instructions belong to this device. It contains important details concerning operation and handling. You
should therefore keep them safe and pass them on, when you install this product for a third party.
For a fast response of your technical enquiries please contact or consult our Technical Advisory Service:
Germany: Tel. + 49 9604 / 40 88 80
Fax + 49 9604 / 40 88 48
E-mail: [e-mail]
Mon to Thurs 8.00am to 4.30pm
Fri 8.00am to 2.00pm
Read through the following operating instructions thoroughly before connecting or commissioning the device. They not only show
you the correct operating procedure but also help you to exploit all the device's technical options.
Intended use
This airbrush extraction system effectively prevents the spread of spray mist. The filtered air can escape via the discharge. The
discharge for the extraction hose can be adjusted in three directions. The rotary table (Ø 250 mm) allows the perfect processing of
the object. The airbrush extraction system is also suitable for soldering and gluing work.
Only use the product in dry indoor locations.
Any use other than the one described above will damage the product. Moreover, there is a danger of, for example, short-circuits, fire,
electric shock, etc. No part of the product must be modified or rebuilt and the housing must not be opened!
The safety instructions must be observed at all times!