User manual

Supported Use Cases 19
Doc.Id. HMSI-27-205
Anybus Wireless Bridge - Ethernet to WLAN
Doc.Rev. 1.30
3.3 Two Wireless Bridges Connected as Ethernet Bridge
- Alternative 3
3.3.1 Overview
This use case uses two Wireless Bridges connected in Ethernet Bridge mode. Here, one of the modules
is connected to a wired network and it does NOT use the wireless connection. Managed (infrastructure)
mode is used.
3.3.2 Set Up the Use Case
This use case can be set up by the SMART button.
To use the automatic configuration in Managed mode, the Network Name (SSID) and security param-
eters (Encryption, Authentication, User Name and Key) must be configured manually (using the web
interface or AT commands), unless intending to use the default values. For further information on the
web interface, see section “Using the Web Configuration Interface” on page 10.
Alternative 1 - SMART mode
1. Power on the first module and enter SMART configuration mode 8 (wait for automatic config-
uration).
2. Power on the second module (the one on the wired network) and enter SMART configuration
mode 10 (initiate automatic configuration, wired).
3. The first module will now have the IP address 192.168.0.98 and the second will have
192.168.0.99. The modules will operate in Managed mode.