User manual

Doc.Id. HMSI-27-205
Anybus Wireless Bridge - Ethernet to WLAN
Doc.Rev. 1.30
Chapter 2
2. General Concepts
2.1 Configuration Methods
The Wireless Bridge supports four main methods for setting and configuring the module:
1. Smart mode
Use the buttons and LED’s on the Wireless Bridge to automatically set up the most common use
cases.
2. Web interface
An online web interface with the most common settings for the Wireless Bridge.
3. AT commands
Connect to the Wireless Bridge over Ethernet using TCP, or directly on Layer 2 and use a termi-
nal such as Hyperterminal to issue AT commands. This method is mainly for more advanced set-
tings and use cases, and is not described in this document. All commands available in the web
interface and much more are supported throught the use of AT commands.
4. The SNMP protocol
This will not be used or described in this document.
2.2 Using SMART Configuration Mode
If the Mode button is pressed within 5 seconds from power up, the Wireless Bridge will enter SMART
configuration mode. The LED’s above the button (A, B, C, and D) will show the mode currently select-
ed. When the required mode is selected, it must be confirmed by holding in the Mode button for two
seconds. This will cause the LED’s to start flashing during the operation of the selected mode.