Instructions / Assembly

ManualsBrandsUnbranded ManualsBell Buttons & Wall PlatesWireless Door Bell Push Button, White

HOMEDEPOT.COM

Please contact 1-855-556-1852 for further assistance.

Use and Care

Guide

Wireless Push Buttons

ITEM #1001 406 884, #1001 406 886,

#1001 406 887

MODEL #216592, #216593,

#216594, & #216595

Installation

ACTIVATING THE PUSH BUTTON BATTERY

□ Remove the front cover of the push button by inserting a ﬂat

head screwdriver in the slot on the bottom of the button and

pulling up slightly.

□ Remove the plastic tab from the battery compartment to

allow connection to the terminal.

□ Snap the front cover onto the base by ﬁrst hooking the tops

together, then snapping the base on.

□ Repeat for second button if applicable.

POWERING THE CHIME

□ Install the chime batteries or plug in the chime, following the

instructions included in the chime.

SYNCING THE CHIME AND PUSH BUTTON

□ Follow the instructions included in the chime.

MOUNTING THE PUSH BUTTON

□ Remove the front cover from the base by following step 1.

□ Mount the push button base to a clean wall or door jamb

with included screws or mounting tape. If mounting with

screws, predrill a pilot hole through the push button base in

the desired location using a 5/64 in. drill bit.

□ Snap the push button cover onto the base by ﬁrst hooking

the tops together, then snapping the base on.

216595Inst.ai

TOOLS REQUIRED

Phillips screwdriver Flat Head Screwdriver Drill

HARDWARE INCLUDED

#4x3/4

#6x3/4

#4x1 White Zinc

#6x1 Self Tapping

ScrewHardware.ai

(2) #4 x 3/4 in. Screws (1) Adhesive Sticker

216595Inst.ai

5/64 in. Drill Bit

216595Inst.ai

#4x3/4

#6x3/4

#4x1 White Zinc

#6x1 Self Tapping

ScrewHardware.ai

Summary of content (3 pages)

PAGE 1
Wireless Push Buttons ITEM #1001 406 884, #1001 406 886, #1001 406 887 MODEL #216592, #216593, #216594, & #216595 Use and Care Guide #4x3/4 TOOLS REQUIRED HARDWARE INCLUDED #6x3/4 #4x3/4 Phillips screwdriver Flat Head Screwdriver Drill (2) #4 x 3/4 in. Screws #4x1 White Zinc (1) Adhesive Sticker #6x1 Self Tapping #6x3/4 5/64 in. Drill Bit ScrewHardware.ai Installation 1 #4x1 White Zinc ACTIVATING THE PUSH BUTTON BATTERY 216595Inst.
PAGE 2
Safety Information You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. WARNING: Keep batteries out of reach of children. This Device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. 2. This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
Warranty WHAT IS COVERED The Warrantor is pleased to extend this Warranty to you, the original consumer/end user (“Consumer”) of the doorbell products and listed by model number below (“Doorbell Product”). This Warranty is valid for any Doorbell Product used in standard residential applications, and may not be assigned or transferred by you.