Use and Care Manual

Operator’s Manual
Chipper Shredders
17
Check for parts online at w ww.tazztools.com or call 800-345-6007 M-F 8-5
INSPECT CHIPPING KNIVES
Service Interval: Every 25 hours, or as necessary
The chipping knives of this unit can be rotated or sharpened
to provide a new cutting surface as required. When inspect-
ing the knives be careful to avoid touching the sharpened
edges. To inspect the chipping knives:
1. Disconnect the spark plug wire and secure it away from
the spark plug. SEE FIGURE 12
2. Remove the nuts securing the chipper cone to the front
of the chipper. Remove the chipper cone (A) to access
the knives. SEE FIGURE 11
3. Using the recoil starter, slowly pull the starter rope to
rotate the rotor into position so the blades can be seen.
To sharpen or replace the chipper knives, see the Trouble-
shooting and Repair section.
Check / Change Engine Air Cleaner
Service Interval: Every 25 hours
The engine air cleaner assembly should be opened, inspected,
and the lter element replaced every 25 hours, or as required if
debris has built up in the assembly.
To replace the air lter, see engine manual.
Replace Spark Plug
Please contact your authorized dealer to perform this service.
Oil Maintenance
Refer to engine manual for oil maintenance.
CAUTION
FOR THE SAFETY OF THE USER, AND TO MAXIMIZE
THE LIFE OF THE ENGINE, IT IS CRUCIAL TO TAKE
TIME TO CHECK THE CONDITION OF THE ENGINE.
PROBLEMS MUST BE CORRECTED BEFORE
OPERATING.
AVOID INJURY! ENGINE OIL IS HAZARDOUS TO
YOUR HEALTH. DISPOSE OF OIL APPROPRIATELY.
USE A SAFE DISPOSAL/RECYCLING CENTER.
IMPORTANT
ENGINE IS SHIPPED FROM FACTORY WITHOUT
OIL. YOU MUST ADD ENGINE OIL BEFORE
STARTING ENGINE.
FIGURE 11- Inspect Chipper Knives
A. Chipper Cone
A
FIGURE 12
A. Spark Plug Cap/Wire
A