Manualshelf

Instructions / Assembly

ManualsBrandsUnbranded ManualsDoor Chimes & KitsWhite 85 dB Wireless Battery Operated Door Bell Kit with 1-Push Button with White Wireless Door Bell Push Button
123
HOMEDEPOT.COM
Please contact 1-855-556-1852 for further assistance.
Use and Care
Guide
Wireless Battery-Powered
Doorbell Kit
ITEM #1001 406 909 &
#1001 406 915
MODEL #216601 & #216602
Installation
1
ACTIVATING THE PUSH BUTTON BATTERY
□ Remove the front cover of the push button by inserting a flat
head screwdriver in the slot on the bottom of the button and
pulling up slightly.
□ Remove the plastic tab from the battery compartment to
allow connection to the terminal.
□ Snap the front cover onto the base by first hooking the tops
together, then snapping the base on.
□ Repeat for second button if applicable.
2
INSERTING THE CHIME BATTERIES
□ Remove the battery compartment cover from the back of the
chime.
□ Insert (3) AA batteries as shown in the diagram on the chime
and replace the battery compartment cover.
3
SYNCING THE CHIME AND PUSH BUTTON
The chime and included push button(s) already come synced.
Follow the steps below if you need to resync, or sync
additional push buttons.
□ Press and release the learning button on the inside of the chime.
□ Immediately following, press and release the push button to
hear a 2-note tune. Press and release the push button again
within five seconds to hear another tune. Continue pressing
and releasing the push button until you reach the desired tune.
To set that tune, do not push the push button for five seconds.
4
MOUNTING THE CHIME
□ Snap the back cover onto the chime.
□ Mark the desired screw locations on a clean wall.
□ Drill a pilot hole on each mark using a 3/16” drill bit and
insert the wall anchors.
□ Screw in the included #6 screws and mount the door chime
to the screws.
216602_216601Inst.ai
TOOLS REQUIRED
Phillips screwdriver Flat Head Screwdriver (3) AA Batteries
HARDWARE INCLUDED
#4x3/4
#6x3/4
#4x1 White Zinc
#6x1 Self Tapping
ScrewHardware.ai
(2) #6 x 3/4 in.
Screws
Drill 3/16” Drill Bit 5/64” Drill Bit
(2) Wall Anchors
216602_216601Inst.ai
216602_216601BInst.ai
Learning
mode
button
216602_216601Inst.ai
(1) or (2) Adhesive
Stickers depending
on model
(2) or (4) #4 x 3/4 in.
Screws depending
on model
216602_216601Inst.ai
#4x3/4
#6x3/4
#4x1 White Zinc
#6x1 Self Tapping
ScrewHardware.ai
#4x3/4
#6x3/4
#4x1 White Zinc
#6x1 Self Tapping
ScrewHardware.ai

Summary of content (3 pages)