DrufelCNC www.drufelcnc.com Contents 1. Application launch............................................................................................. 2 2. Customization ................................................................................................... 3 2.1. Controller Configuration ........................................................................... 3 2.2. Axis setting ................................................................................................ 4 2.3.
DrufelCNC www.drufelcnc.com Application launch To run the application, use the version depending on the bitness of your operating system: DrufelCNCx32.exe - version for 32-bit operating systems DrufelCNCx64.exe - version for 64-bit operating systems Main window of the program. The bottom left corner shows the connection status to the USB controller.
DrufelCNC www.drufelcnc.com Customization To set up communication with the controller, you must click on the button with the key image . Controller Configuration In the opened window go to the tab “Device controller”. In the equipment section, you must select a controller by setting a point in the radio box opposite the USB controller. Next, you need to save the settings.
DrufelCNC www.drufelcnc.com Axis setting To set up a stepper motor or servo drive, go to the “Axes settings” tab. Set the required number of pulses for each axis. Next, you need to save the settings.
DrufelCNC www.drufelcnc.com Configure Input Ports To configure the input ports, go to the “Input ports” tab. Set the input port numbers according to the machine configuration. Next, you need to save the settings.
DrufelCNC www.drufelcnc.com Configure Output Ports To configure output ports, go to the “Output ports” tab. Set output port numbers according to machine configuration. Next, you need to save the settings.
DrufelCNC www.drufelcnc.com Spindle adjustment To configure the parameters of the spindle, you must go to the tab “Spindle”. Set the speed and acceleration according to the spindle specification. Set the default spindle rotation direction. Next, you need to save the settings.
DrufelCNC www.drufelcnc.com Run the control program (G-code) To run the control program in the G-code language, you need to click on the button with the image of the folder, then select the file. If the file is recognized successfully, a three-dimensional file model will be displayed on the right side of the main window. To start processing the blank, click the button “Start” 9 .
DrufelCNC www.drufelcnc.com Opening HPGL files To open files in HPGL format, you must click on the button with the image of the folder, then select the file. In the window that opens, you must select the options for converting HPGL to G-Code. After successful conversion you will see a three-dimensional model of the file.
