Instructions / Assembly

4
6
8
How To Solvent Weld
Prior To Use:
Read all product labels carefully.
Stir or shake cement before using. If jelly-like, do not use.
Keep container closed when not in use. Avoid eye and skin
contact. Wear safety glasses with side shields and wear
rubber gloves.
1. Square pipe ends, chamfer and remove all dirt.
2. Check dry fit of pipe and fitting. Pipe should easily go
1/3 of the way into the fitting. If pipe bottoms, it should
be snug.
3. Use a suitable applicator at least 1/2 the size of the pipe
diameter. For larger size pipe systems use a natural
bristle brush or roller.
4. Clean pipe and fitting with a listed primer.
(Do not use primer on ABS pipe and fittings.
Use Clear Cleaner only!)
5. Apply liberal coat of cement to pipe to the depth of the
socket, leave no uncoated surface.
6. Apply a thin coat of cement to inside of fitting, avoid
puddling of cement. Puddling can cause weakening and
premature failure of pipe or fitting. Apply a second coat
of cement to the pipe.
7. Assemble parts QUICKLY. Cement must be fluid.
If cement surface has dried, recoat both parts.
8. Push pipe FULLY into fitting using a 1/4 turning motion
until pipe bottoms.
9. Hold pipe and fitting together for 30 seconds to prevent
pipe push-out – longer at low temperatures. Wipe
off excess.
10. Allow 15 minutes for good handling strength and 2 hours
cure time at temperatures above 60°F before pressure
testing up to 180 psi. Longer cure times may be required
at temperatures below 60°F or with pipe above 3". DO
NOT TEST WITH AIR.
For specialty cements and chemical applications please see
specific product label instructions.
Pipe Types
CPVC: Chlorinated Poly Vinyl Chloride – Typically used
for pressure piping applications, including hot and cold
potable water distribution. Can also be used for corrosive
fluid handling in industrial or chemical applications.
ABS: Acrylonitrile Butadiene Styrene – Typically used for
non-pressure piping applications.
PVC: Poly Vinyl Chloride – Typically used for pressure
or non-pressure piping applications.
Solvent Cements
for any Application
If you need to solvent weld one pipe joint or one thousand,
Oatey is the solvent cement more professionals choose than
any other brand. From hot to cold, wet to dry, Oatey has
the solvent cement to meet your exact requirement for any
plastic pipe installation.
Product Development
Oatey Solvent Cements are developed with the plumbing
contractor in mind. Extensive research and product develop-
ment provide you peace of mind and confidence when using
Oatey brand solvent cements. In addition, no company
works as hard as Oatey on behalf of the professional plumber
with regulatory and coding agencies.
1 2
3
5
7
9