Installation Guide

Wall

Installation

Parts Supplied:

Please unpack your range hood

when it is delivered and inspect

to ensure all parts are included.

1. Main Hood with all lights

and button banks pre-

installed.

2. Adjustable Stainless

Chimney Cover

3. Flexible duct (not

pictured)

4. Packet of screws and

anchors

5.Top mounting bracket

PAGE 1
Wall Installation Parts Supplied: Please unpack your range hood when it is delivered and inspect to ensure all parts are included. 1. Main Hood with all lights and button banks preinstalled. 2. Adjustable Stainless Chimney Cover 3. Flexible duct (not pictured) 4. Packet of screws and anchors 5.
PAGE 2
Seven Easy Steps to Installing Wall Hoods Step one: Find the center of the wall where you are installing the hood. Make sure there is sufficient bracing to hold the weight of the hood. Mark your center line and measure out from center to find your two mounting points. Make sure your mounting points are level when you mark them. It is recommended to install the hood directly into wood supports. fig 1 center line 1 fig.
PAGE 3
Step 5: Make your electrical and ducting connections. Use 6” rigid duct wherever possible. Try and minimize the use of elbows. More elbows and longer runs create higher static pressure. The hood comes with a grounded three prong plug that can either be direct wired or plugged into a 20 amp. circuit. fig. 4 fig. 4 Step 6: Install the 2 part chimneys on top of the hood by sliding the inside section up until the vertical vent slots are visible.