Installation Guide

1.
2.
3.
Remove the drawer.
Remove the existing drawer slides from the drawer box and cabinet.
Prepare the the cabinet and drawer for the new slides by filling old
holes and sanding any rough spots that may interfere. Proceed to New
Cabinetry Installation.
New Cabinetry Installation
Seperate the slide members by depressing the release lever.
Instructions for the Side Mount Extension Drawer Slides:
Note: When replacing existing drawer slides, confi rm that the new slide
has a load rating that will meet expected drawer load, uses a similar
mounting style, is the correct length and will fi t within the available
space. Requires a minimum clearance of 1/2” per drawer side. When using
back sockets, drawer must be 1” to 1-1/16” less than cabinet opening.
Existing Cabinet Installation
1. Install drawer members
Place the front edge of each member 1/16” for face frame cabinets or 1/8”
for 32mm frameless cabinets from the rear face of the drawer front. Fasten
each drawer member using two truss-head screws per member through
the vertical slots only. Check that the ball retainer is moved fully forward to
the stop.
2. Install cabinet members
Fasten each cabinet member into place using One screw through the front
mounting hole and one through the rear mounting hole as well as one in
the optional* rear mounting bracket. For 32mm frameless cabinets, check
the hole pattern of the cabinet members with those of the cabinet - the
pattern on the cabinet should be set back 1-1/2” from the cabinet face.
Place the cabinet member 2mm from Euro hole pattern. Vertically align and
install members in the desired position.
3. Insert, adjust and secure
Move the ball retainer to the front of the cabinet member. Insert the
drawer by placing the drawer member between the balll bearings and
carefully pushing the drawer until it closes. Open and close the drawer to
check fi t and operation. Make any neccesary adjustments and place the
remaining screws.
*Optional Rear Bracket Mounting Instructions: Fasten two 1” x 2”
wood mounting strips to the rear inside wall. Align the wider face of the
strips parallel to the face frame. Position and fasten rear mounting
brackets to the strips. Install two screws into each bracket after adjusting.
Place each member flush with the front of the cabinet opening. Make sure
it is perpen-dicular to the cabinet front and in a level position.
Instructions
Slide Mounting