Installation Guide

ManualsBrandsUnbranded ManualsCabinet Hardware24 in. Side Mount Full Extension Ball Bearing Drawer Slides

Instructions for the CSH 1170 and 1180 Full Extension Drawer

Slides:

Note: When replacing existing drawer slides, conﬁ rm that the new slide has

a load rating that will meet expected drawer load, uses a similar mounting

style, is the correct length and will ﬁ t within the available space. Requires a

minimum clearance of 1/2” per drawer side. Drawer must be 1” to 1-1/16”

less than cabinet opening.

Existing Cabinetry Installation

1. Remove the drawer.

2. Remove the existing drawer slides from the drawer box and cabinet.

3. Prepare the the cabinet and drawer for the new slides by ﬁ lling old holes

and sanding any rough spots that may interfere. Proceed to New Cabinetry

Installation.

New Cabinetry Installation

Seperate the slide members by depressing the relese lever.

1. Install drawer members

Place the front edge of each member 1/16” for face frame cabinets or 1/8”

for 32mm frameless cabinets from the rear face of the drawer front. Fasten

each drawer member using two pan-head screws per member through the

vertical slots only. Check that the ball retainer is moved fully forward to the

stop.

2. Install cabinet members

Fasten each cabinet member into place using One screw through the front

mounting hole and one through the rear mounting hole as well as one in

the optional

39.1170 rear mounting bracket. For 32mm frameless cabinets,

check the hole pattern of the cabinet members with those of the cabinet -

the pattern on the cabinet should be set back 1-1/2” from the cabinet face.

Place the cabinet member 2mm from Euro hole pattern. Vertically align and

install members in the desired position.

3. Insert, adjust and secure

Move the ball retainer to the front of the cabinet member. Insert the drawer

by placing the drawer member between the balll bearings and carefully

pushing the drawer until it closes. Open and close the drawer to check ﬁ t

and operation. Make any neccesary adjustments and place the remaining

screws.

*Optional Rear Bracket Mounting Instructions:

Fasten two 1” x 2”

wood mounting strips to the rear inside wall. Align the wider face of the

strips parallel to the face frame. Position and fasten rear mounting brackets

to the strips.Install two screws into each bracket after adjusting. Place each

member ﬂ ush with the front of the cabinet opening. Make sure it is perpen-

dicular to the cabinet front and in a level position.

1170 and 1180

100 Pound

Capacity Drawer

Slide Mounting

Instructions

Summary of content (1 pages)

PAGE 1
170 and 1180 100 Pound Capacity Drawer Slide Mounting Instructions Instructions for the CSH 1170 and 1180 Full Extension Drawer Slides: Note: When replacing existing drawer slides, conﬁrm that the new slide has a load rating that will meet expected drawer load, uses a similar mounting style, is the correct length and will ﬁt within the available space. Requires a minimum clearance of 1/2” per drawer side. Drawer must be 1” to 1-1/16” less than cabinet opening. Existing Cabinetry Installation 1.