Installation Guide

1) Place the garbage disposal directly beneath the sink strainer opening.

Place the manufacturer’s supplied parts on top of the garbage disposal

in this order: snap ring, triangular flange with screws, base plate and

fiber gasket.

Part number 3H2013

THE PLUMBER’S THIRD HAND

Garbage Disposal Installation Tool

Makes installing a Garbage Disposal

as easy as 1

PATENT PENDING

5) TURN THE SPIN-DOWN COUNTER-CLOCKWISE UP APPROXIMATELY

6 INCHES and remove the installation tool.

2) Insert the installation tool through the sink strainer and into the opening

of the garbage disposal. PUSH DOWN AND THEN PULL UP TO SECURE

THE TOOLS BASE PLATE TO THE INSIDE WALL OF THE DISPOSAL.

3) Lift the disposal from the cabinet base about 2 inches. SPIN THE SPIN-

DOWN CLOCKWISE DOWN INTO THE STRAINER OPENING. The weight

of the disposal suspended from the tool will hold the sink strainer firmly

in place. Two hands are now free to install the manufacturers supplied

parts previously placed on top of the disposal to the strainer base.

Tighten the TRIANGULAR PLATE screws firmly against the base plate.

4) Lift the disposal up to the sink strainer base. SPIN THE SPIN-DOWN INTO

THE STRAINER OPENING. TURN THE SPIN-DOWN CLOCKWISE BRING-

ING THE DISPOSAL FIRMLY AGAINST THE SINK STRAINER BASE. DO

NOT OVER TIGHTEN. With two hands NOW FREE turn the manufacturers

preinstalled locking ring counter clockwise securing the disposal to the

lugs of the sink strainer base. Tighten it up.

Before installing Disposal, follow manufacturers instructions for installing the discharge elbow,

electrical connection, dishwasher knockout (if applicable), and sink strainer.

If you have quesons, contact us at 860-536-1860.