Instructions / Assembly
ISTEAM3 CONTROL INSTALLATION
Control
Pigtail
Control
Cable
Steam
Generator
1a
F
1 2 :1 6
PM
S T A R T
9 7
F
1
2 : 1
6
P
M
M
M
S T A R
T
9
7
R
T
STEP 1
PLUG the 30’ control cable into the iSteam3 control pigtail (1a).
Turn the generator on and test the control to verify correct
connection. With proper function, proceed to Step 2.
CAUTION
Do not force or twist cable ends together.
Forcing or twisting cable ends may damage
the connectors.
IMPORTANT: Turn power to the steam
generator OFF before installing the control.
Failure to turn the power off will result in an
inoperable control.
ISTEAM3 CONTROL INSTALLATION
1313
Step 2
Peel the double stick adhesive off the back of the iSteam3 control (2a).
Apply a bead of silicone around the rear of the iSteam3 control to
create a moisture seal (2b).
Carefully feed the cables into the rough-in box and secure the
control to the wall. Care must be taken to not pinch the cables.
Ensure the control is level.
IMPORTANT NOTE: The control must be installed with the arrow on the
Peel-Off screen protector facing up. If the Peel-Off screen protector has been
removed see the drawing in Step 2b for the proper orientation. The control
display can be ipped 180 degrees in the settings menu if installed upside
down.
NOTE: The silicone supplied by MrSteam can be used to meet a variety of
sealing and gasketing. It cures to silicone rubber and adheres to glass, wood,
metal, porcelain, ceramic tile, painted surfaces, many plastics and rubber.
Surfaces must be clean and dry. Apply thin layer of product. Fit together and
support if necessary. Allow excess material to cure, then trim with a sharp
blade. Sealant “skins” in 5 minutes, dries to touch in 1 hour. Fully cures and
bonds in 24 hrs.
IMPORTANT NOTE: Do not apply excessive amounts of silicone.
Do not apply silicone to any other parts of the control including the adhesive
gasket. Insure the mounting surface is clean and dry as required for good
adhesion. Hold the control with the arrow on the screen protector facing
up and press the control against the wall until the adhesive sticks and holds
rmly. Control may have to be supported or secured until the silicone has
cured for 24 hours.
F
1 2: 16
PM
S T AR T
9 7
F
1
2 :1
6
P
M
M
S T AR
T
9
7
2a
2b
2c
This
End
Up
This
End
Up
Before use, remove
and discard the peel off
screen protector.
IMPORTANT The information in this guideline is designed to provide a general overview of how MrSteam products are installed. The diagrams are for Illustrative purposes only. NEVER use this document for the Installation,
Operation or Maintenance of any MrSteam product. For Installation, Operation and Maintenance information, only use the specic Installation, Operation and Maintenance manual supplied with each Mr. Steam product. The
specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product contains important information required for the safe and reliable installation and operation of the product. Failure to use
the specic Installation, Operation and Maintenance manual that is supplied with each Mr. Steam product may result in product damage, property damage, death or personal injury. If you do not have an Installation, Operation
and Maintenance manual please contact MrSteam for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of any MrSteam product please
contact a customer or technical service representative using the contact information on the back cover of this guideline.